 |
 |
Intelligent
chemical products
Introducing products that activate upon contact
with contamination and stabilize once the contamination is
gone. These products enable practically any type of system
to be cleaned of problematic deposits without sustaining damage.
One can easily see the exceptional advantages such products
have to offer.
These products render possible the effective
elimination of ferrous and non-ferrous oxidation, lime and
organic deposits, oils and grease including synthetic compounds,
without attacking the surface of metal, rubber, polymer, wood,
or other material. In addition, since the residues are completely
dissolved, there is no risk of blockage during the application.
Used according to instructions,
Gotar products remove all traces of contamination without damaging
the surface being cleaned. When the application is finished,
the surface is entirely clean.
Traditional Acid
Violent acids traditionally used for cleaning
react uniformly as long as they are in contact with the surface.
However, after the contamination has been removed from a particular
area of the surface, this violent acid continues to react, etching
the metal and sometimes even causing permanent damage.
Sandblasting
This method causes two major inconveniences.
To begin with, the surface is attacked by a fast stream of
abrasives, which can easily cause damage. In addition, the
high pressure of the abrasive stream causes particles of oxidation
to penetrate the surface. This method cannot prevent the emergence
of rust, even when the surface is treated with a protective
coating immediately after cleaning.
Gotar
Gotar descalers or deoxidizers stop reacting
once the contamination has been dissolved. This allows the
cleaning action to continue where needed even if it has finished
elsewhere, resulting in a uniformly clean surface.
The revolutionary formulation of
Gotar products yields deoxidizers, descalers, and degreasers
with specific reactive properties. They react only at the exact
location required. This characteristic is extremely important
for cleaning systems comprised of multiple materials. It allows
the system to be cleaned without dismantling it to protect sensitive
parts from coming in contact with the acid.
|
Traditional acid
|
|
Gotar
|
 |
|
 |
| |
|
Seals and gaskets between metal parts are not affected
by Gotar products. |
|
Traditional acid
|
|
Gotar
|
 |
|
 |
| |
|
|
The cleaning of heat exchangers is a good illustration
of the advantages of the selective reaction of Gotar products.
The very thin plates that make up the system can be effectively
and safely cleaned without dismantling them. |
One of the major benefits of Gotar technology is the restoration
of equipment to its original, fully functional state. When
the system goes back into operation, all its components will
have been completely cleaned, even if the original contamination
varied in severity.
Traditional Acid
The traditional acid cleaning process must
be stopped once the product used begins to etch the metal surface.
However, contamination in the system is often spread unequally.
As a result, the system is not totally free of all contamination
when it is put back into operation.
Gotar
Gotar descalers act upon the corroded or
contaminated area without damaging the metal's surface. The
cleaned system can then go into full operation under optimal
conditions.
|
|
|
 |
Contents
|
|
|
